VENT-AXIA CANADA

A current sensor is a great addition to the dryer booster fans in your home, apartment or condo. The unit senses as soon as your clothes dryer draws more than 1 amp of current. It automatically turns on the booster fan, eliminating additional sensors, switches or speed controls. When the current frop below the pre-set 2-amp threshold, the Con-Cur booster fan control automatically shuts off the booster fan.

The Con-Cur booster fan control can be installed in three ways:

• INSIDE DRYER

1. Mount the Con-Cur current sensor in convenient location inside dryer connection compartment.
2. Disconnect and loop neutral (white) dryer power supply wire through current sensor cut-out, then reconnect.
3. Connect fan 120v-AC power supply to top (relay) terminals of Con-Cur Control.

• AT DRYER JUNCTION BOX

1. Attach electrical junction box to dryer hunction box.
2. Disconnect and loop neutral (white) dryer power supply wire through current sensor cut junction box and re-connect.
3. Mount Con-Cur current sensor in electrical box (May require drilling 2 mounting holes).
4. Connect fan 120v-AC power supply to top (relay) terminals of Con-Cur Control.

• AT BREAKER

1. Mount Con-Cur current sensor in convenient location on fuse/breaker panel.
2. Disconnect and lopp neutral (white) dryer power supply wire through current sensor cut.
3. Connect fan 120v-AC power supply to top (relay) terminals of Con-Cur Control.

To go back to Comfort Agencies Inc click Here.

This entry was posted on Friday, February 23rd, 2007 at 11:49 am and is filed under Installations. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.